pyrite recovery circuit

Mineralogical and Metallurgical Examination of ,

Mineralogical and Metallurgical Examination of Fluorosilicate Mineral Flotation in the Ok Tedi Circuit L S Pang urn 1, D W Lauder2, E V Manlapig 1, I R Mackinnon3 and J W Glatthaar4 ABSTRACT The Ok Tedi copper orebody consists of porphyry and skarn orebodi

Pyrite recovery mechanisms in rougher flotation circuits ,

This circuit consists of four parallel banks of seven 130 m 3 mechanical cells Results of testing the first rougher cell (approximately 69% Cu recovery), showed that 40–60% of pyrite in the finer class of the concentrate (−45 μm) was recovered by entrainment

Gravity Concentration | Gekko

Determining the mineralogy of an ore material is critical for optimising the operation of a gravity circuit Whether the mineral is free or occluded with other sulphides, or whether multiple liberating particle sizes exist, will help determine the optimal gravity flowsheet design for the best recovery of mineral

Pyrite-Gold Recovery in Copper Rougher Flotation Tailings

unintentional pyrite flotation is undesirable in a Cu-Au ore flotation circuit due to the detrimental effect on Cu final grade Therefore, in order to improve final concentrate grade, pyrite depression strategies (eg aeration, sulphite, cyanide addition, etc) have been used over the years to minimise pyrite recovery


Grade-Recovery Optimiser With the increase in availability of online grade analysis, it is now possible to manipulate the flotation circuit operating conditions to optimise plant performance Developed as a result of these advancements, the FloatStar Grade-Recovery Optimiser provides continuous, online optimisation of circuit operation throughout

Stabilization of lead and Zinc Flotation Circuits

mineral was pyrite (Circa 3 to 5% Fe in Mill Feed This CW ore type predominated the first 6 years of production, but in August 2002, the ore mineralogy changed due to significantly , concentrates and recovery of lead from the circuit upstream of the zinc circuit

Clay depression - Pionera

Clay depressant in a gold and copper bulk flotation plant trial In production at a Gold and Copper flotation circuit the use of PIONERA F-100 showed a recovery increase in gold of 5% and a positive effect on the copper recovery by successfully depressing clay in the bulk flotation process

Gold Fingers - How to Recover Gold from Electronic Scrap ,

Dec 19, 2013· goldnscrap In this video tutorial i'm showing how to recover gold from electronic circuit board scrap Specifically the gold plating that is f.

Developing a Bulk Circuit Suitable for Chalcopyrite Pyrite ,

The chalcopyrite and pyrite losses in the tailing from the rougher circuit were the same for both bulk and sequential roughing (less than 6%) In cleaning (bulk circuit), the effective pH for pyrite depression was about 118 The copper recovery was 70% (grade of 20% copper) and the sulfur recovery (pyrite product) was 80% (grade of 36% sulfur)

An Alternative Circuit for Chalcopyrite-Pyrite Ores with ,

A simpler flotation circuit with lower operating and capital costs for treatment of such copper-gold-pyrite ores with an elevated pyrite head assay was sought in the described work After characterising the ore, the objective was to apply bulk rougher flotation of both the copper minerals and pyrite for the copper-gold-pyrite ore at natural pH

The Process – NewCo Gold

Traditional recovery Tailings retreatment in South Africa began in the 1970s incorporating a technique known as flotation to recover pyrite uranium and gold A CIL circuit was later added to enhance gold production Three decades had passed before NEWCO GOLD acquired the Brakpan plant in 2007 with the aim of re-establishing the Ergo project

EP0568672B1 - Flotation separation of arsenopyrite from ,

Arsenopyrite is separated from a mixture with pyrite by contacting the mixture with a sulfitic agent providing HSO3- ions at elevated temperature and pH below about 8 for a period sufficient to impart a selective depression property to the arsenopyrite On addition of a collector the pyrite is rendered floatable, enabling froth flotation to achieve a concentrate rich in pyrite and tailings .

Silver Gold Recovery Flotation Process

The ores from which silver and gold are recoverable by flotation divide themselves naturally into two general processing classes: ores in which the valuable minerals are those of the base metals, the precious metals being incidental constituents, and ores in which the gold and silver are of primary importance, the base-metal minerals, if present, being of little or no value The first class .

Gold Mining Process Development – Denver Mineral Engineers

allow the recovery of gold by standard gravity concentration or direct cyanide , crystalline structure of sulfide minerals such as pyrite and arsenopyrite For cyanide to leach gold, the cyanide solution must come into direct contact , small cyanide mills to reduce the complexity and cost of the circuit There are several disadvantages to .

Flotation Circuit Design for Adanac Moly Corp using a ,

one specific grade/recovery point, but rather, shift up and down the grade/ recovery curve that is dictated by the feed, reagent conditions and the physical configuration of the circuit Various circuit configurations can be compared by producing the grade/recovery curves generated when each circuit treats the same feed, with the same reagents, but


flotation circuit was set-up to recover the zinc Laboratory test work results realized Cu-Zn recovery differential from a Cu/Zn separation circuit of over 40-45% This performance has been achieved in the plant, at 72% Cu overall recovery With the gradual improvements on-going with zinc circuit capacity and

MEI Blog: Flotation '17 Conference Diary

Pyrite is a gangue mineral commonly associated with valuable sulphide minerals, such as chalcopyrite, chalcocite, galena and sphalerite The separation of pyrite from these valuable sulphide minerals by flotation is difficult due to the activation of pyrite by lead and ,

The development of regrind-flotation pre-treatment of the ,

improve the performance of the CIL (Carbon-in-Leach) circuit at copper-gold concentrators Occlusion of gold by iron sulphide gangue minerals and the fine grain size of gold associated with them contribute to the low gold recovery in the CIL circuit Fine grinding of the CIL feed increased gold recovery significantly from the leaching process

Gravity Gold Recovery and Gold Flotation Recovery Process

Flotation Simulation & Modelling Software to Improve Grade & Recovery Metallurgy BUY Laboratory & Small Plant Process Equipment We have all the laboratory and plant equipment you need to test or build/operate your plant

pyrite table circuit - woningbedrijfwarnsveldnl

Pyrite recovery mechanisms in rougher flotation circuits , Bubble load and top of froth measurements per size class were carried out in a rougher flotation circuit containing sulphide copper minerals and pyrite This circuit consists of four parallel banks of seven 130 m 3 mechanical cells

Improved Cleaner CIrCuIt performanCe at the degrussa ,

Improved Cleaner CIrCuIt performanCe at the degrussa Copper mIne wIth an In sItu Column spargIng system J Knoblauch1 - principle metallurgist H Thanasekaran2 - senior process engineer E Wasmund3 - global managing director More information is available at eriez˜otation 1

Gold Mining Equipment | Gold Wash Plant for Sale - JXSC Mining

This process is a widely used process in China's gold plant, in which the recovery rate of gold can reach 30-60% 5 Cyanidation (full mud cyanidation) process Applicable to gold with a higher emerald grain size, a deeper iron ore-bearing pyrite quartz vein type ore, or a gold-altered diorite-type ore

Electrochemical properties of pyrite, pyrrhotite, and ,

circuit potentials of pyrite, pyrrhotite, and steel electrodes with respect to the reference electrode To verify the results, two , effects on the recovery and selectivity of minerals during flotation Methods and materials Figure 1 shows the circuit that was used to measure open-circuit potentials In this circuit, potential differences between

pyrite depression in the copper flotation

Pyrite Depressant on copper ore Froth Flotation Am looking at what can be used to depress pyrite in sulphide ore without affecting copper recovery greatly Am currently undertaking a project on the depression of pyrite, am trying to use aeration and milling at high pH and its proving to work but at the expense of copper recovery Live Chat

Major Mines & Projects | Chelopech Mine

May 02, 2019· Pyrite Recovery Circuit (completed March 2014) Prompted by the success of the cleaner circuit upgrade, the new pyrite circuit included the SFR design as the flotation units The remainder of the circuit includes a concentrate thickener, filter, and concentrate storage area located on the west side of the current concentrator building

Development of a Pyrite Regrind Circuit at Telfer Gold ,

The gold recovery of the CIL circuit is below the industry standard and operates with a high reagent consumption rate With a new fine-grinding facility, the Telfer process plant will have the ability to liberate copper and gold from the pyrite concentrate and recover these by flotation prior to the existing leaching circuit

Major Mines & Projects | Bradshaw Project

The rougher tailings are fed to pyrite flotation stage for pyrite recovery, if required The sequential flotation circuit without applying ore-sorting generates two concentrate products: - arsenopyrite concentrate (64%* mass recovery / 93% gold recovery); - pyrite concentrate (48% mass recovery / 3% gold recovery)

Evaluating Copper Rougher-Scavenger Flotation Circuit ,

The recovery of liberated grains of sphalerite into the rougher and scavenger concentrate increases linearly with flotation time Overall 15% of the liberated grains of sphalerite are recovered in the combined rougher scavenger concentrate Liberated pyrite and non-sulphide gangue minerals are efficiently rejected out the scavenger tail stream

Depression of pyrite in porphyry copper flotation

• Pyrite in the feed was Cu activated , and adsorbed xanthate even at high pH (>105), becoming highly floatable • Limited pyrite depression was achieved by increasing the pH with lime • Na 2SO 3and DETA were effective in preventing/reversing the activation of pyrite in the presence of O2, reducing pyrite recovery by 50%

Recovery of Gold in Pyritic Sulfide Ores - Mine EngineerCom

information on pyrtiric gold, leach Recovery of Gold in Pyritic Sulfide Ores The now extinct Us Bureau of Mines conducted numerous studies of gold in pyrite, and sulfide ores over the years, until their untimely demise in the 1990's

24/7 Service

We have set up a team with hundreds of technical engineers to resolve a series of problems during project consultation, on-site surveys, sample analysis, program design, installation, commissioning and maintenance guidance.